Table of Contents
Advertisement
Serial port
3. The serial port is enabled by default. To disable:
(config)> serial port1 enable false
(config)>
4. Set the mode:
(config)> serial port1 mode login
(config)>
5. (Optional) Set a label that will be used when referring to this port.
(config)>path-paramlabel label
(config)>
6. Set the baud rate used by the device to which you want to connect:
(config)>serial port1 baudrate rate
(config)>
7. Set the number of data bits used by the device to which you want to connect:
(config)>serial port1 databits bits
(config)>
8. Set the type of parity used by the device to which you want to connect:
(config)>serial port1 parity parity
(config)>
Allowed values are:
even
n
odd
n
none
n
The default is none.
9. Set the stop bits used by the device to which you want to connect:
(config)>serial port1 stopbits bits
(config)>
10. Set the type of flow control used by the device to which you want to connect:
(config)>serial port1 flow value
(config)>
where value is one of:
n
none
n
rts/cts
n
xon/xoff
TX40 User Guide
Configure Login mode
239
Advertisement
Table of Contents
