Table of Contents
Advertisement
Interfaces
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show Surelink status for a specific interface
To show the Surelink status a specific interface, use the
command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show surelink interface name name
interface, for example:
> show surelink interface name eth1
Interface
---------
eth1
eth1
Passingsing
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show Surelink status for all IPsec tunnels
To show the Surelink status all IPsec tunnels, use the
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type :
> show surelink ipsec all
IPsec
------
test
test
test1
test2
>
IX10 User Guide
Test
-----------------------------
Interface is up
Interface's DNS servers (DNS)
Test
--------------------
194.43.79.74 (Ping)
194.43.79.75 (Ping)
194.43.79.74 (Ping)
194.43.79.75 (Ping)
Show Surelink status and statistics
show surelink interface name name
command to show the Surelink status of a specific
Proto
Last Response
-----
-------------
IPv4
32 seconds
IPv4
28 seconds
show surelink ipsec all
Last Response
Status
-------------
------------------
29 seconds
Passed
5 seconds
Passed
21 seconds
Failed
21 seconds
Waiting for result
Status
-------
Passing
command:
159
Advertisement
Table of Contents
