Digi TX40 User Manual page 136

Interfaces
4. If carrier section mode is set to manual or manual_automatic, set the network PLMN ID:
(config)> network interface wwan1 modem operator plmn_ID
(config)>
Note You can use the
and determine their PLMN ID. See
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Scan for available cellular carriers
You can scan for available carriers and determine their network PLMN ID by using the
command at the Admin CLI.

Web
Log into the TX40 WebUI as a user with full Admin access rights.
1. From the main menu, click Status > Modems.
2. For the appropriate modem, scroll to the Connection Status section and click SCAN.
The Carrier Scan window opens.
3. (Optional) Change the Timeout for the carrier scan. The default is 300 seconds.
4. When the Carrier Scan window opens, the results of the most recent previous scan are
displayed. If there is no previous scan available, or to refresh the list, click SCAN.
TX40 User Guide
modem scan command at the Admin CLI to scan for available carriers
Scan for available cellular carriers
Wide Area Networks (WANs)
for details.
modem scan
136