Add A Usb Serial Port - Digi TX40 User Manual

Serial port
4. Set the stop bits used by the device to which you want to connect:
(config)>serial port1 stopbits bits
(config)>
5. Set the type of flow control used by the device to which you want to connect:
(config)>serial port1 flow value
(config)>
where value is one of:
n none
n rts/cts
n xon/xoff
7. Save the configuration and apply the change
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Add a USB serial port

Your TX40 can be configured to support USB-to-serial adapters for serial access to the device, remote
serial out-of-band (OOB) access to other devices, or for use in python applications. The following USB-
to-serial chipsets are supported:
FTDI
n
Prolific
n
To add a USB serial port:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
TX40 User Guide
Use Digi Remote Manager to view and manage your
Add a USB serial port
281