Table of Contents
Advertisement
Interfaces
11. Configure default slice information:
a. Enable the default slice for this modem:
(config)> network modem wwan1 default_slice_info enabled true
(config)>
b. Set the type of slice to be used:
(config)> network modem wwan1 default_slice_info sst value
(config)>
where value is one of:
n
n
n
The default is EMBB.
c. (Optional) Add additional information that supplements the SST to differentiate among
multiple network slices of the same SST:
(config)> network modem wwan1 default_slice_info sd string
(config)>
12. Save the configuration and apply the change
(config)> save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure cellular modem APNs
The TX40 device uses a preconfigured list of Access Point Names (APNs) when attempting to connect
to a cellular carrier for the first time. After the device has successfully connected, it will remember the
correct APN. As a result, it is generally not necessary to configure APNs. However, you can configure
the system to use a specified APN.
To configure the APN:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
TX40 User Guide
EMBB: Enhanced Mobile Broadband.
URLLC: Ultra-Reliable Low-Latency Communications.
MIOT: Massive Internet of Things.
Use Digi Remote Manager to view and manage your
Wide Area Networks (WANs)
123
Advertisement
Table of Contents
