Table of Contents
Advertisement
User authentication
d. Assign the user to the admin group:
i. Click Groups.
ii. For Add Group, click .
iii. For Group, select the admin group.
a. Verify that the admin group has full administrator rights:
i. Click Authentication > Groups.
ii. Click admin.
iii. Verify that the admin group has Admin access enabled. If not, click Admin access to
enable.
iv. Verify that Access level is set to Full access. If not, select Full access.
7. Click Apply to save the configuration and apply the change.
Command line
1. Configure a user on the RADIUS server:
a. On the ubuntu machine hosting the FreeRadius server, open the /etc/freeradius/3.0/users
file:
$ sudo gedit /etc/freeradius/3.0/users
b. Add a RADIUS user to the users file:
admin1 Cleartext-Password := "password1"
In this example:
n
n
n
c. Save and close the users file.
2. Configure a user on the TACACS+ server:
a. On the ubuntu machine hosting the TACACS+ server, open the /etc/tacacs+/tac_plus.conf
file:
$ sudo gedit /etc/tacacs+/tac_plus.conf
TX40 User Guide
Unix-FTP-Group-Names := "admin"
The user's username is admin1.
The user's password is password1.
The authentication group on the TX40 device, admin, is identified in the Unix-FTP-
Group-Names parameter.
Example user configuration
897
Advertisement
Table of Contents
