Table of Contents
Advertisement
Interfaces
(config)> network bridge lan1 stp forward_delay num
(config)>
The default is 2 seconds.
6. Save the configuration and apply the change
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a bridge
Required configuration items
A name for the bridge.
n
Bridges are enabled by default.
Devices to be included in the bridge.
n
Additional configuration items
n
Enable Spanning Tree Protocol (STP).
To create a bridge:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
TX40 User Guide
Use Digi Remote Manager to view and manage your
Bridging
228
Advertisement
Table of Contents
