Table of Contents
Advertisement
Wi-Fi
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
1. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Network (LAN)
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
2. Save the configuration and apply the change
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Edit an existing Access point
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Show available access points:
(config)> network wifi ap ?
Additional Configuration
------------------------------------------------------------------------
-------
digi_ap1
digi_ap2
(config)>
4. Set the SSID for the appropriate access point:
(config)> network wifi ap digi_ap1 ssid my_SSID
(config)>
5. SSID broadcasting is enabled by default for the preconfigured access points. If SSID
broadcasting is disabled:
(config)> network wifi ap digi_ap1 ssid_broadcast true
(config)>
TX40 User Guide
and
Configure a bridge
for more information.
Digi AP (Wi-Fi1)
Digi AP (Wi-Fi2)
Configure a Wi-Fi access point with personal security
Configure a Local Area
320
Advertisement
Table of Contents
