Digi TX40 User Manual page 550

Table of Contents

Advertisement

Virtual Private Networks (VPN)
e. Repeat for each additional test.
12. Add recovery actions:
a. Click to expand Recovery actions.
By default, there are two preconfigured recovery actions:
n
n
b. Click .
New recovery actions are enabled by default. To disable, click to toggle off Enable.
c. Type a Label for the recovery action.
d. For Recovery type, select Reboot device.
e. For Recovery type, select the type of recovery action. If multiple recovery actions are
configured, they are performed in the order that they are listed.
n
n
TX40 User Guide
Test interface: The interface to test.
l
IP version: The type of IP connection, one of:
l
o
Any: Either the IPv4 or IPv6 connection must be up.
o
Both: Both the IPv4 or IPv6 connection must be up.
o
IPv4: The IPv4 connection must be up.
o
IPv6: The IPv6 connection must be up.
Expected status: The status required for the test to past.
l
o
Up: The test will pass only if the referenced interface is up and passing its
own SureLink tests (if applicable).
o
Down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
Update routing: Uses the Change default gateway action, which increases the
interface's metric by 100 to change the default gateway.
Restart interface.
Change default gateway: Increases the interface's metric to change the default
gateway.
If Change default gateway is selected, complete the following:
Attempts: The number of attempts for this recovery action to perform, before
l
moving to the next recovery action.
Increase metric to change active default gateway: Increase the interface's
l
metric by this amount. This should be set to a number large enough to change
the routing table to use another default gateway. The default is 100.
Override wait interval before performing the next recovery action: The
l
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
Restart interface.
If Restart interface is selected, complete the following:
OpenVPN
550

Advertisement

Table of Contents
loading

Table of Contents