Table of Contents
Advertisement
Wi-Fi
n
WPA2 Enterprise: Uses WPA2 enterprise security mode.
n
WPA3 Enterprise: Uses WPA3 enterprise security mode.
Note
device will have WPA3 capabilities.
9. Configure one or more RADIUS servers:
a. Click to expand RADIUS server list.
b. Click to expand RADIUS server.
c. For RADIUS IP/hostname, type the IP address or hostname of the RADIUS server.
d. (Optional) Change the RADIUS port. The default port is 1812.
e. For RADIUS secret key, type the secret key as configured on the RADIUS server.
f. To add additional RADIUS servers, click
10. (Optional) For Group rekey interval, type the amount of time to wait before changing the
group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
Allowed values are any number of days, hours, minutes, or seconds, and take the format
number{d|h|m|s}.
For example, to set Group rekey interval to ten minutes, enter 10m or 600s.
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
11. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Network (LAN)
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
12. Click Apply to save the configuration and apply the change.
Command line
TX40 User Guide
Only select WPA3 Enterprise if you know that all Wi-Fi clients connecting to this
and
Configure a bridge
for more information.
Configure a Wi-Fi access point with enterprise security
Configure a Local Area
325
Advertisement
Table of Contents
