Table of Contents
Advertisement
Services
Note
This list is synchronized with the list of servers included with NTP client configuration,
and changes made to one will be reflected in the other. See
more information about NTP client configuration.
8. Enable Use GNSS module to use the on-board GNSS module as a time source.
9. See
Information Technology for Public Transport (ITxPT) support
configuring the NTP service for ITxPT.
10. (Optional) Configure the system time zone. The default is UTC.
a. Click System > Time
b. Select the Timezone for the location of your TX40 device.
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the ntp service:
(config)> service ntp enable true
(config)>
4. (Optional) Add an upstream NTP server that the device will use to synchronize its time to the
appropriate location in the list of NTP servers. The default setting is time.devicecloud.com.
To delete the default NTP server, time.devicecloud.com:
n
(config)> del service ntp server 0
(config)>
To add the NTP server to the beginning of the list, use the index value of 0 to indicate
n
that it should be added as the first server:
(config)> add service ntp server 0 time.server.com
(config)>
To add the NTP server to the end of the list, use the index keyword end:
n
(config)> add service ntp server end time.server.com
(config)>
To add the NTP server in another location in the list, use an index value to indicate the
n
appropriate position. For example:
TX40 User Guide
Network Time Protocol
Configure the system time
for information about
for
731
Advertisement
Table of Contents
