Default Outbound Wan/Wwan Ports - Digi TX40 User Manual

Interfaces
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click the menu icon (...) next to the name of the WAN or WWAN to be deleted and select
Delete.
5. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the del command to delete the WAN or WWAN. For example, to delete a WWAN named
my_wwan:
(config)> del network interface my_wwan
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Default outbound WAN/WWAN ports

The following table lists the default outbound network communications for TX40 WAN/WWAN
interfaces:
Description
Digi Remote Manager connection to edp12.devicecloud.com .
NTP date/time sync to time.devicecloud.com .
DNS resolution using WAN-provided DNS servers.
HTTPS for modem firmware downloads from
firmware.devicecloud.com .
TX40 User Guide
Wide Area Networks (WANs)
Port
TCP/UDP number
TCP 3199
UDP 123
UDP 53
TCP 443
165