Digi TX40 User Manual page 374

Hotspot
Note Setting the Maximum upload speed to 0 means that the bandwidth is unlimited. This
can have an adverse effect on performance.
19. (Optional) Click Debug to enable verbose logging to the system log.
20. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Create new access points for the hotspot.
You can also use existing access points for the hotspot. Access Points that are assigned to a
hotspot or to a bridge used by a hotspot cannot be used for any other purpose.
If more than one access point is being used by the hotspot, you must create a bridge that
includes the access points.
a. Create a new access point:
(config)> add network wifi ap new_hotspot_AP1
(config network wifi ap new_hotspot_AP1)>
New access points are enabled by default.
b. Set the Wi-Fi radio for the new access point:
i. Show available radios:
(config network wifi ap new_hotspot_AP1)> radio ?
Radio: The Wi-Fi radio to run this access point on.
Format:
TX40 User Guide
Hotspot configuration
374