Isolate Clients Connected To Different Access Points - Digi TX40 User Manual

Wi-Fi
3. Create a new access point or modify an existing access point. See
access point,
point with enterprise
4. (Optional) Set the client isolation:
(config)> network wifi ap digi_ap1 isolate_client true
(config)>
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Isolate clients connected to different access points

Isolating clients that are on different access points involves the following steps:
1. Assign the access points to separate LAN interfaces.
2. Assign those LAN interfaces to separate firewall zones.
3. Create firewall filters to prevent traffic between the two firewall zones.

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX40 User Guide
Configure a Wi-Fi access point with personal
security.
Use Digi Remote Manager to view and manage your
Isolate Wi-Fi clients
Configure an open Wi-Fi
security, or Configure a Wi-Fi access
332