Table of Contents
Advertisement
Services
__|%s|__|%v|__
14. Type a four-digit alphanumeric Vehicle ID that will be included with to location messages. If
no vehicle ID is configured, this setting defaults to 0000.
15. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a remote host to which location messages will be sent:
(config)> add service location forward end
(config service location forward 0)>
4. Set the hostname or IP address of the remote host to which location messages will be sent:
(config service location forward 0)> server host
(config service location forward 0)>
5. Set the communication protocol to either upd or tcp:
(config service location forward 0)> protocol protocol
(config service location forward 0)>
6. Set the TCP or UDP port on the remote host to which location messages will be sent:
(config service location forward 0)> server_port 8000
(config service location forward 0)>
7. Set the number of Location update intervals to wait before forwarding location data to this
server. See
update interval.
(config service location forward 0)> interval_multiplier int
(config service location forward 0)>
8. Set the protocol type for the messages. Allowed values are taip or nmea; the default is taip:
(config service location forward 0)> type nmea
(config service location forward 0)>
(Optional) If the protocol type is set to nmea:
a. Configure a Talker ID.
TX40 User Guide
Configure the location service
for more information about setting the Location
Location information
690
Advertisement
Table of Contents
