Table of Contents
Advertisement
Serial port
To limit access to specified IPv4 addresses and networks:
n
ii. For Add Address, click .
iii. For Address, enter the IPv4 address or network that can access the device's
iv. Click again to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
ii. For Add Address, click .
iii. For Address, enter the IPv6 address or network that can access the device's
iv. Click again to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the TX40 device:
ii. For Add Interface, click .
iii. For Interface, select the appropriate interface from the dropdown.
iv. Click again to allow access through additional interfaces.
TX40 User Guide
i. Click IPv4 Addresses.
service-type. Allowed values are:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the service-type.
l
i. Click IPv6 Addresses.
service-type. Allowed values are:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
l
i. Click Interfaces.
Configure Remote Access mode
243
Advertisement
Table of Contents
