Use A Dead Reckoning External Usb Gnss Receiver - Digi TX40 User Manual

Services
Alternatively, you can use the index number to delete the DNSS location source:
(config)> del service location 1
(config)>
4. (Optional) Set a label for this location source:
(config)> service location source 1 label "label"
(config)>
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Use a dead reckoning external USB GNSS receiver

The TX40 device supports an external USB GNSS receiver to provide dead reckoning-based location
information. The USB GNSS receiver is available for purchase from Digi International Inc..
The ability to use an external USB GNSS receiver is enabled by default. After purchasing the
USB GNSS receiver, plug it into a USB port on the TX40, and it will begin providing location
information.
To disable support for the external GNSS receiver, or enable it if it has been disabled:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
TX40 User Guide
Use Digi Remote Manager to view and manage your
Location information
678