Table of Contents
Advertisement
Services
n
To limit access based on firewall zones:
(config)> add service telnet acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to include additional firewall zones.
4. (Optional) Configure Multicast DNS (mDNS)
mDNS is a protocol that resolves host names in small networks that do not have a DNS server.
mDNS is disabled by default. To enable:
(config)> service telnet mdns enable true
(config>
5. (Optional) Set the port number for this service.
The default setting of 23 normally should not be changed.
(config)> service telnet port 25
(config)>
6. Save the configuration and apply the change
(config)> save
Configuration saved.
>
TX40 User Guide
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
(config)>
Configure telnet access
647
Advertisement
Table of Contents
