Table of Contents
Advertisement
Interfaces
Configure a DHCP server
Note
These instructions assume you are configuring the device to use its local DHCP server. For
instructions about configuring the device to use a DHCP relay server, see
Required configuration items
n
Enable the DHCP server.
Additional configuration items
n
The lease address pool: the range of IP addresses issued by the DHCP server to clients.
n
Lease time: The length, in minutes, of the leases issued by the DHCP server.
n
The Maximum Transmission Units (MTU).
n
The domain name suffix appended to host names.
n
The IP gateway address given to clients.
n
The IP addresses of the preferred and alternate Domain Name Server (DNS), NTP servers, and
WINS severs that are given to clients.
n
The TFTP server name.
n
The filepath and name of the bootfile on the TFTP server.
n
Custom DHCP options. See
options.
n
Static leases. See
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
TX40 User Guide
Configure DHCP options
Map static IP addresses to hosts
Use Digi Remote Manager to view and manage your
Local Area Networks (LANs)
Configure DHCP
for information about custom DHCP
for information about static leases.
relay.
197
Advertisement
Table of Contents
