Table of Contents
Advertisement
Services
n
To disable the sevice:
(config)> service web_admin enable false
(config)>
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the service
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Web administration.
4. (Optional) For Port, enter the port number for the service. Normally this should not be
changed.
5. Click Access control list to configure access control:
To limit access to specified IPv4 addresses and networks:
n
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 address or network that can access the device's web
TX40 User Guide
administration service. Allowed values are:
Configure the web administration service
Use Digi Remote Manager to view and manage your
626
Advertisement
Table of Contents
