Show Surelink Status For A Specific Interface - Digi IX40 User Manual

Table of Contents

Advertisement

Interfaces
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type :
> show surelink interface all
Interface Test
--------- ----------------------------- ----- ------------- -------
eth1
Interface is up
eth1
Interface's DNS servers (DNS) IPv4 28 seconds
eth2
Interface is up
eth2
Interface's DNS servers (DNS) IPv4 20 seconds
modem
modem
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show SureLink status for a specific interface

To show the SureLink status a specific interface, use the
command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show surelink interface name name
interface, for example:
> show surelink interface name eth1
wan1 Surelink Status
--------------------
IPv4 Status : Passing
IPv6 Status : Failed
Test
----------------------------- ----- ------------- ------
Interface's DNS servers (DNS) IPv6 15 seconds
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX40 User Guide
Proto Last Response Status
IPv4 32 seconds
IPv4 21 seconds
Interface is up
IPv4 115 seconds Passing
Interface's DNS servers (DNS) IPv4 114 seconds Passing
Proto Last Response Status
Show SureLink status and statistics
Passing
Passing
Passing
Passing
show surelink interface name name
command to show the Surelink status of a specific
Failed
225

Advertisement

Table of Contents
loading

Table of Contents