Temporarily Set The Ignition Power Delay - Digi TX40 User Manual

System administration

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. To set the ignition power on delay:
(config)> system power ignition on_delay value
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set the ignition power on delay to ten minutes, enter either 10m or 600s:
(config)> system power ignition on_delay 600s
(config)>
The default is 0s, meaning that there is no power on delay.
4. To set the ignition power off delay:
(config)> system power ignition off_delay value
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set the ignition power off delay to ten minutes, enter either 10m or 600s:
(config)> system power ignition off_delay 600s
(config)>
The default is 0s, meaning that there is no power off delay.
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Temporarily set the ignition power delay

By default, the TX40 device automatically powers on when it detects power on the ignition sensor,
and powers off when it detects that there is no power on the ignition sensor.
You can temporarily set the device's ignition power off delay without changing the device
configuration by using the
maintenance activities, such as a firmware update, to occur after the ignition is switched off.
TX40 User Guide
system power ignition off_delay
Power ignition sensor
command. This allows for one-time
990