Digi TX40 User Manual page 936

Firewall
ix. Set the destination address type:
(config network qos 2 policy 0 rule 0)> dst type value
(config network qos 2 policy 0 rule 0)>
where value is one of:
Repeat to add a new rule. Up to 30 rules can be configured.
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
TX40 User Guide
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
n mac: Only traffic from the MAC address typed in MAC address will be matched.
Set the MACaddress to be matched:
(config network qos 2 policy 0 rule 0)> src mac MAC_address
(config network qos 2 policy 0 rule 0)>
n any: Traffic destined for anywhere will be matched.
See Firewall configuration
n interface: Only traffic destined for the selected Interface will be matched. Set
the interface:
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config network qos 2 policy 0 rule 0)> dst interface
/network/interface/wan1
(config network qos 2 policy 0 rule 0)>
address: Only traffic destined for the IP address typed in IPv4 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
address6: Only traffic destined for the IP address typed in IPv6 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
Configure Quality of Service options
for more information about firewall zones.
936