Table of Contents
Advertisement
Services
The Configuration window is displayed.
3. Click Services > Location > Location sources > usb.
4. (Optional) Type a Label for the USB location source.
5. For Type of location source, leave the selection at USB module.
6. Click Enable the location source to disable the USB GNSS receiver, or to enable it if it has
been disabled.
7. Alternatively, you can also delete the usb location source:
a. Click the menu icon (...) next to the usb location source.
b. Click Delete.
8. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the USB module:
a. Use the show command to determine the index number of the USB location source:
(config)> show service location source
0
1
(config)>
TX40 User Guide
enable true
no label
type usb
enable true
no label
type gnss
Location information
679
Advertisement
Table of Contents
