Table of Contents
Advertisement
Services
Repeat this step to include additional firewall zones.
To limit access to specified IPv4 addresses and networks:
n
(config)> add service location source 2 acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the location server UDP port.
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service location source 2 acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the location server UDP port.
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the TX40 device:
n
(config)> add service location source 2 acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add service location source 2 acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
TX40 User Guide
(config)>
Display a list of available interfaces:
Use ... network interface ? to display interface information:
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
Location information
686
Advertisement
Table of Contents
