Digi TX40 User Manual page 924

Firewall
6. For Session timeout, type the amount of time that a user session remains valid. After the
session times out, the user will be required to log in again.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Session timeout to ten minutes, enter 10m or 600s.
7. For Portal HTTP access, configure whether the portal can be accessed over an insecure
connection.
n Allow: Allows access to the portal page over an insecure connection (HTTP port 80).
n Redirect to HTTPS: Automatically redirects the request to a secure connection (HTTPS
port 443).
Disallow: Does not allow access over an insecure connection (HTTP port 80).
n
Note This setting does not affect access to HTTP port 80 after the client has been granted
access to the portal.
8. For Authorization, select the method that will be used to authorize the user:
n None: Users are not required to enter any information to access the portal.
n User login: Users are required to authenticate with an account on this device. Users
must be part of a user group that allows access to this portal.
n Collect user information: Users are required to complete a form to continue. The form
fields may be customize.
9. (Optional) For Title, enter the title of the portal page that the user will see when accessing the
portal.
10. (Optional) For Message, enter a message that will appear on the portal page.
11. (Optional) For Terms and Conditions, enter the terms and conditions that ill appear on the
portal page. Users will be required to agree to the terms and conditions before being granted
access to the portal.
12. (Optional) For Redirect to URL, enter the URL to which the user will be directed when granted
access to the portal. If left blank, the user will be directed to the domain of the URL in the
original access request.
13. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
TX40 User Guide
Configure captive portals
924