Digi TX40 User Manual page 899

User authentication
2 local
(config)>
6. Verify that the admin group has full administrator rights:
(config)> show auth group admin acl
admin
enable true
level full
...
(config)>
If admin > enable is set to false:
(config)> auth group admin acl admin enable true
(config)>
If admin > level is set to read-only:
(config)> auth group admin acl admin level full
(config)>
7. Configure the local user:
a. Create a local user with the username admin1:
(config)> add auth user admin1
(config auth user admin1)>
b. Assign a password to the user:
(config auth user adminuser)> password password1
(config auth user adminuser)>
c. Assign the user to the admin group:
(config auth user adminuser)> add group end admin
(config auth user adminuser)>
8. Save the configuration and apply the change
(config auth user adminuser)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX40 User Guide
Example user configuration
899