Firmware Configuration; Review Tx40 Default Settings; Local Webui; Digi Remote Manager - Digi TX40 User Manual

Firmware configuration

Review TX40 default settings

You can review the default settings for your TX40 device by using the local WebUI or Digi Remote
Manager:

Local WebUI

1. Log into the TX40 WebUI as a user with Admin access. See
details.
2. On the menu, click System > Device Configuration.

Digi Remote Manager

1. If you have not already done so, connect to your Digi Remote Manager account.
2. From the menu, click Devices to display a list of your devices.
3. Locate your device as described in
4. Click the Device ID.
5. Click Settings.
6. Click to expand Config.
The following tables list important factory default settings for the TX40.

Default interface configuration

Interface type
Wide Area Network
(WAN)
Wireless Wide-Area
Networks (WWANs)
TX40 User Guide
Use Digi Remote Manager to view and manage your
Preconfigured interfaces
n WAN
n WWAN1
Review TX40 default settings
Using the local web interface
Devices Default configuration
n Ethernet: n Firewall zone:
ETH1 External
n WAN priority:
Metric=1
IP Address: DHCP
n
client
Digi SureLink
n
enabled for IPv4
n WWAN1 n Firewall zone:
cellular External
n WAN priority:
modem
Metric=3
n SIM failover after 5
attempts
Digi SureLink
n
enabled for IPv4
for
device.
TM
TM
34