Table of Contents
Advertisement
Services
n
To limit access based on firewall zones:
a. Click Zones.
b. For Add Zone, click .
c. For Zone, select the appropriate firewall zone from the dropdown.
d. Click again to allow access through additional firewall zones.
9. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a location source:
(config)> add service location source end
(config service location source 02)>
4. (Optional) Set a label for this location source:
(config service location source 02)> label "label"
(config service location source 02)>
5. Set the type of location source to server:
(config service location source 02)> type server
(config service location source 02)>
6. Set the UDP port that will receive incoming location messages.
(config service location source 02)> server port port
(config service location source 02)>
7. Click Access control list to configure access control:
n
To limit access to specified IPv4 addresses and networks:
(config)> add service location source 1 acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the location server UDP port.
l
Repeat this step to list additional IP addresses or networks.
TX40 User Guide
See
Firewall configuration
for information about firewall zones.
Location information
684
Advertisement
Table of Contents
