Wan Bonding - Digi TX40 User Manual

Services
wan1
wan1
wan1
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

WAN bonding

Digi International Inc. offers a WAN bonding service as a licensed feature.
WAN bonding, a part of SD WAN (Software Defined Wide Area Networking), allows multiple internet
connections to be piped together to provide increased throughput. It also provides for assured data
delivery by duplicating packets inside the bonded tunnel to insure that latency and connection issues
on different internet connections do not result in dropped packets.
WAN bonding also provides seamless failover by automatically using multiple pipes within the bonded
tunnel.
The WAN bonding service for your TX40 device must be enabled in Digi Remote Manager. Contact your
Digi sales representative for information.
This section contains the following topics:
Use Digi Remote Manager to enable and configure WAN bonding on multiple devices
Configure WAN bonding on your local device
Show WAN bonding status and statistics
TX40 User Guide
fe80::227:4ff:fe2b:ae12
fe80::227:4ff:fe44:105b
fe80::240:ffff:fe80:23b0
WAN bonding
655
658
663
654