Show Lan Status And Statistics - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

f. Set the SSID for the Digi AP (Wi-Fi2) access point:

(config)> network wifi ap digi_ap1 ssid Example2

g. Set the password for the Digi AP (Wi-Fi2) access point:

(config)> network wifi ap digi_ap2 encryption key_psk2 password2

9. Save the configuration and apply the change:

(config network bridge LAN2)> save

Configuration saved.

10. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Task three: Verify the new configuration

The final step in this example is to verify the new configuration.

1. Connect an Ethernet cable from an internet-connected modem to WAN1 through the

WAN/ETH1 Ethernet port.

2. Verify that LAN1 is operating correctly:

a. Connect a device to LAN1 through the ETH2 Ethernet port, or by connecting to the Digi AP

(Wi-Fi) (single-WiFi models) or Digi AP (Wi-Fi1) (dual-WiFi models) access point.

b. Verify that the device has been provided an IP address from the LAN1 DHCP server in the

192.168.2.* subnet.

3. Verify that LAN2 is operating correctly:

a. Connect a device to LAN2 through the ETH3 Ethernet port, or by connecting to the Digi AP

(Wi-Fi2) access point (dual WiFi models only).

b. Verify that the device has been provided an IP address from the LAN2 DHCP server in the

192.168.3.* subnet.

Show LAN status and statistics

1. Log into the TX54 WebUI as a user with Admin access.

2. From the menu, click Status.

3. Under Networking, click Interfaces.

Command line

1. Log into the TX54 command line as a user with Admin access.

TX54 User Guide

Local Area Networks (LANs)