Table of Contents
Advertisement
Interfaces
network.interface.modem.ipv4;
ACTION
update_routing_table 00/03
restart_interface
reset_modem
switch_sim
modem_power_cycle
restart_interface
>
Show SureLink status for all interfaces
To show the SureLink status all interfaces, use the
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type :
> show surelink interface all
Interface
---------
eth1
eth1
eth
eth
modem
modem
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show SureLink status for a specific interface
To show the SureLink status a specific interface, use the
command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show surelink interface name name
interface, for example:
IX10 User Guide
ATTEMPTS
00/03
00/03
00/03
00/03
00/03
Test
-----------------------------
Interface is up
Interface's DNS servers (DNS)
Interface is up
Interface's DNS servers (DNS)
Interface is up
Interface's DNS servers (DNS)
Show SureLink status and statistics
-> restart_interface
STATUS
[ BUSY ]
show surelink interface all
Proto
Last Response
-----
-------------
IPv4
32 seconds
IPv4
28 seconds
IPv4
21 seconds
IPv4
20 seconds
IPv4
115 seconds
IPv4
114 seconds
show surelink interface name name
command to show the Surelink status of a specific
command:
Status
-------
Passing
Passing
Passing
Passing
Passing
Passing
181
Advertisement
Table of Contents
