Customize The Hotspot Login Page - Digi TX40 User Manual

Hotspot
8C-2D-2D-C8-41-AA
0/0
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Customize the hotspot login page

The TX40 device provides three sample HTML webpages for use with the hotspot feature. When
hotspot is enabled for the first time, the sample webpages are installed to the /etc/config/hotspot
folder on the device's filesystem. By default, the hotspot redirects users to one of the sample
webpages based on the authentication mode being used. See
information about which HTML file is used for each authentication mode. The sample HTML webpages
use ChilliLibrary.js to perform authentication. Do not modify ChilliLibrary.js.
You can customize the sample HTML pages, or replace them with your own page, so that hotspot
users will be redirected to your custom HTML page when they log into the hotspot. You can also host
the HTML pages on an external web server, rather than on the TX40 device. See
for information about configuring the HTML page that the hotspot will use.
This section contains the following topics:
Edit sample hotspot HTML pages
Upload custom hotspot HTML pages
Restore hotspot default sample pages
TX40 User Guide
10.1.0.101 yes mariev
0/0
Customize the hotspot login page
0/0
Hotspot authentication modes
Create a new hotspot
0/0
for
397
398
400
396