Enable Hotspot Using The Default Configuration - Digi TX40 User Manual

Hotspot

Enable hotspot using the default configuration

The default configuration of the TX40 device's hotspot is:
Hotspot
Bridge
Access points
LAN
To use the default hotspot with click-through authentication, enable the hotspot, the bridge, the
access points, and the LAN.
In additional to enabling the default hotspot configuration, you may also want to:
TX40 User Guide
Default configuration
n Name: hotspot
n Disabled
n Authentication mode: Click-through
IP address: 10.1.0.1/24
n
DHCP server: Automatically enabled
n
DHCP server lease range: 100-250
n
n Bandwidth limits:
Maximum download speed: 10000 Kbps
l
Maximum upload speed: 10000 Kbps
l
n Name: hotspot_bridge
n Disabled
n 2.4 GHz Wi-Fi access point: Digi Hotspot AP (Wi-
Fi1)
5 GHz Wi-Fi access point: Digi Hotspot AP (Wi-
n
Fi2)
n Name:
Digi Hotspot AP (Wi-Fi1)
l
Digi Hotspot AP (Wi-Fi2)
l
Disabled
n
SSID: Digi Hotspot
n
Encryption: Open (unencrypted)
n
n Hotspot access points should be set to open
(unencrypted). See Hotspot security
information.
Name: LAN hotspot
n
Disabled
n
Device: hotspot_bridge
n
n IP address: 192.168.100.1/30
This IP address is not used by the hotspot or the
hotspot's DHCP server. It must be a unique IP
address that is not used elsewhere in your
network.
n DHCP server: Disabled
The hotspot will use the hotspot's DHCP server
n
rather than the LAN's DHCP server.
Hotspot configuration
for further
355