Table of Contents
Advertisement
Serial port
c. Set the type of parity used by the device to which you want to connect:
(config serial USB_port)> parity parity
(config serial USB_port)>
Allowed values are:
n
n
n
The default is none.
d. Set the stop bits used by the device to which you want to connect:
(config serial USB_port)> stopbits bits
(config serial USB_port)>
e. Set the type of flow control used by the device to which you want to connect:
(config serial USB_port)> flow type
(config serial USB_port)
Allowed values are:
n
n
n
The default is none.
7. If mode is set to remote:
a. Set the characters used to start an escape sequence:
(config serial USB_port)> escape string
(config serial USB_port)
If no characters are defined, the escape sequence is disabled. The default is ~b.
b. Limit access to the serial port to a single active session:
(config serial USB_port)> exclusive true
(config serial USB_port)
c. Set the number of bytes of output from the serial port that are written to buffer. These
bytes are redisplayed when a user connects to the serial port.
(config serial USB_port)> history bytes
(config serial USB_port)
The default is 4000 bytes.
d. Set the amount of time to wait before disconnecting due to user inactivity:
(config serial USB_port)> idle_timeout value
(config serial USB_port)
TX40 User Guide
even
odd
none
none
rts/cts
xon/xoff
Add a USB serial port
288
Advertisement
Table of Contents
