Table of Contents
Advertisement
Wi-Fi
b. Set the transmit power percentage for the appropriate radio:
(config)> network wifi radio wifi1 tx_power value
(config)>
where value is any integer between 1 and 100 and represents the percentage of transmit
power that the Wi-Fi module should use.
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure an open Wi-Fi access point
This procedure configures a Wi-Fi access point that does not require a password for client
connections.
By default, the TX40 device comes with two preconfigured access points, Digi AP (Wi-Fi1) and Digi AP
(Wi-Fi2). You cannot delete default access points, but you can modify them or you can create your
own access points.
Note
The TX40 supports two Wi-Fi access points.
Required configuration items
n
Enable the Wi-Fi access point
n
Select a Wi-Fi radio for the access point.
n
The Service Set Identifier (SSID) for the access point.
n
Configure open security for the access point.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
access point to a LAN interface or to a bridge. See
Configure a bridge
Additional configuration items
n
Determine whether to broadcast the access point's SSID.
n
Determine whether to isolate clients connected to this access point, so that they cannot
communicate with each other.
n
The amount of time to wait before changing the group key.
To configure a Wi-Fi access point with no security:
Web
TX40 User Guide
for more information.
Configure an open Wi-Fi access point
Configure a Local Area Network (LAN)
and
308
Advertisement
Table of Contents
