Digi TX40 User Manual page 677

Services
Alternatively, you can also delete the gnss location source:
a. Click the menu icon (...) next to the gnss location source
b. Click Delete.
7. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the GNSS module:
a. Use the show command to determine the index number of the GNSS location source:
(config)> show service location source
0
1
(config)>
b. Use the index number to enable or disable the module:
n
n
TX40 User Guide
enable true
no label
type usb
enable true
no label
type gnss
To enable the module:
(config)> service location source 1 enable true
(config)>
To disable the module:
(config)> service location source 1 enable false
(config)>
Location information
677