Table of Contents
Advertisement
Firmware configuration
3. Click Authentication > Users > admin.
4. Enter a new password for the admin user. The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.If the
characters long and must contain at least one uppercase letter, one lowercase letter, one
number, and one special character.
5. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a new password for the admin user. The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.If the
characters long and must contain at least one uppercase letter, one lowercase letter, one
number, and one special character.
(config)> auth user admin password new-password
(config)>
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX40 User Guide
Change the default password for the admin user
primary responder feature
primary responder feature
is enabled, the password must be at least 10
is enabled, the password must be at least 10
40
Advertisement
Table of Contents
