Digi TX40 User Manual page 91

Interfaces
n
f. Repeat for each additional recovery action.
7. Optional SureLink configuration parameters:
a. Type ... to return to the root of the configuration:
(config network interface my_wan surelink actions 0)> ...
(config)>
b. Set the test interval between connectivity tests:
(config)> network interface my_wan surelink interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
TX40 User Guide
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
Set the time to wait before the next test is run. If set to the default value of 0s,
l
the test interval is used.
(config network interface my_wan surelink actions 0)>
override_interval int
(config network interface my_wan surelink actions 0)>
custom_action: Execute custom recovery commands.
If custom_action is selected, complete the following:
Set the number of attempts for this recovery action to perform, before moving
l
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
Set the commands to run to attempt to recovery connectivity.
l
(config network interface my_wan surelink actions 0)> custom_
action_commands_modem "string"
(config network interface my_wan surelink actions 0)>
Set the time to wait before the next test is run. If set to the default value of 0s,
l
the test interval is used.
(config network interface my_wan surelink actions 0)>
override_interval int
(config network interface my_wan surelink actions 0)>
Wide Area Networks (WANs)
91