Table of Contents
Advertisement
Interfaces
1. See
Configure SureLink active recovery to detect WAN/WWAN failures
configuring SureLink.
13. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WAN or edit an existing one:
n
To create a new WAN named my_wan:
(config)> add network interface my_wan
(config network interface my_wan)>
n
To edit an existing WAN named my_wan, change to the my_wan node in the
configuration schema:
(config)> network interface my_wan
(config network interface my_wan)>
4. Set the appropriate firewall zone:
(config network interface my_wan)> zone zone
(config network interface my_wan)>
See
Firewall configuration
5. Select an Ethernet device, a Wi-Fi device, or a bridge. See
bridging.
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_wan)> device ?
Current value:
(config network interface my_wan)> device
b. Set the device for the LAN:
(config network interface my_wan)> device device
(config network interface my_wan)>
TX40 User Guide
for further information.
Wide Area Networks (WANs)
for information about
Bridging
for more information about
147
Advertisement
Table of Contents
