Configure The Wi-Fi Radio's Band And Protocol - Digi TX40 User Manual

Wi-Fi
---------------------------------------------------------------------
----------
wifi1
wifi2
(config)> network wifi radio
b. Set the band for the appropriate radio to 5 GHz:
(config)> network wifi radio wifi1 band 5000mhz
(config)>
c. Enable DFS client support :
(config)> network wifi radio wifi1 5000mhz dfs_client true
(config)>
Note When DFS client support is enabled, any enabled access points that use this radio
will not be started and cannot be used as access points.
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure the Wi-Fi radio's band and protocol

You can configure the band for Wi-Fi radios.

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
TX40 User Guide
Configure the Wi-Fi radio's band and protocol
Wi-Fi1 radio
Wi-Fi2 radio
Use Digi Remote Manager to view and manage your
304