Digi TX40 User Manual page 318

Wi-Fi
wifi1
wifi2
Current value:
(config network wifi ap new_AP)>
b. Set the appropriate radio:
(config network wifi ap new_AP)> radio wifi1
(config network wifi ap new_AP)>
5. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
SSID broadcasting is enabled by default for new access points.
6. Set the security for the access point to a personal security option:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is one of:
n psk: Uses WPA Personal (PSK). All Wi-Fi clients must support WPA to be able to
authenticate.
Note
available. For more information about Primary Responder mode, see
between standard firmware operation and Primary Responder
Note
characters, you can use the wpa_passphrase tool to generate the appropriate pre-
shared key. The wpa_passphrase command is available in the shell console of a DAL OS
Digi device. For details about the command, see the
n mixedpsk: Uses mixed WPA/WPA2 Personal (PSK) mode. Wi-Fi clients that support WPA
and WPA2 are able to authenticate.
Note
available. For more information about Primary Responder mode, see
between standard firmware operation and Primary Responder
n psk2: Uses WPA2 Personal (PSK) mode. All Wi-Fi clients must support WPA2 to be able
to authenticate.
n psk2sae: Uses WPA2-PSK/WPA3-AES mixed mode. Wi-Fi clients that support WPA2 and
WPA3 are able to authenticate.
n sae: Uses WPA3 Personal mode. All Wi-Fi clients must support WPA3 to be able to
authenticate.
TX40 User Guide
When Primary Responder mode is enabled, the WPA personal security mode is not
If you need to configure a Wi-Fi passphrase with any non-printable ASCII
When Primary Responder mode is enabled, the WPA personal security mode is not
Configure a Wi-Fi access point with personal security
wpa_passphrase Linux
Differences
mode.
command.
Differences
mode.
318