Table of Contents
Advertisement
Services
Additional configuration Items
n
The port that the TX40 device's iPerf server will use to listen for incoming connections.
n
The access control list for the iPerf server.
When the iPerf server is enabled, the TX40 device will automatically configure its firewall rules
to allow incoming connections on the configured listening port. You can restrict access by
configuring the access control list for the iPerf server.
To enable the iPerf3 server:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > iPerf.
4. Click Enable.
5. (Optional) For IPerf Server Port, type the appropriate port number for the iPerf server
listening port.
6. (Optional) Click to expand Access control list to restrict access to the iPerf server:
n
To limit access to specified IPv4 addresses and networks:
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 address or network that can access the device's iperf
TX40 User Guide
service. Allowed values are:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the iperf service.
l
Use Digi Remote Manager to view and manage your
Use the iPerf service
765
Advertisement
Table of Contents
