Table of Contents
Advertisement
Interfaces
(config network interface wwan1 modem apn 0) > cid value
(config network interface wwan1 modem apn 0) >
where value is the index number of the SIM that the APN is programmed into. 0 means the
index will be automatically set.
7. (Optional) Set the authentication method:
(config)> network interface wwan1 modem apn 0 auth method
(config)>
where method is one of the following:
n
none: No authentication is required.
n
auto: The device will attempt to connect using CHAP first, and then PAP.
n
chap: Uses the Challenge Handshake Authentication Profile (CHAP) to authenticate.
n
pap: Uses the Password Authentication Profile (PAP) to authenticate.
If auto, chap, or pap is selected, enter the Username and Password required to authenticate:
(config)> network interface wwan1 modem apn 0 username name
(config)> network interface wwan1 modem apn 0 password pwd
(config)>
The default is none.
8. Disable Lightweight M2M support if you are using an AT&T SIM that does not support AT&T
lightweight M2M:
(config)> network interface wwan1 modem apn 0 attm2mglobal false
(config)>
9. (Optional) To configure the device to bypass its preconfigured APN list and only use the
configured APNs:
(config)> network interface wwan1 modem apn_lock true
(config)>
10. Save the configuration and apply the change
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure dual APNs
Some cellular carriers offer a dual APN feature that allows a SIM card to be provisioned with two
separate APNs that can be used simultaneously. For example, Verizon offers this service as its Split
Data Routing feature. This feature provides two separate networking paths through a single cellular
modem and SIM card, and allows for configurations such as:
TX40 User Guide
Wide Area Networks (WANs)
126
Advertisement
Table of Contents
