Table of Contents
Advertisement
System administration
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, enter revert:
(config)> revert
(config)>
4. Set the password for the admin user prior to saving the changes:
(config)> auth user admin password pwd
(config)>
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Custom factory default settings
You can configure your TX40 device to use custom factory default settings. This way, when you erase
the device's configuration, the device will reset to your custom configuration rather than to the
original factory defaults.
Required configuration items
n
Custom factory default file.
Configure the TX40 device to use custom factory default settings
Web
Log into the TX40 WebUI as a user with full Admin access rights.
1. Configure your TX40 device to match the desired custom factory default configuration.
For example, you may want to configure the device to use a custom APN or a particular
network configuration, so that when you reset the device to factory defaults, it will
automatically have your required network configuration.
TX40 User Guide
Erase device configuration and reset to factory defaults
984
Advertisement
Table of Contents
