Digi TX40 User Manual page 301

Wi-Fi
5. For Channel, select the channel. Only channels appropriate for the band are displayed.
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the channel for the radio:
a. Determine available radios:
(config)> network wifi radio ?
Additional Configuration
---------------------------------------------------------------------
----------
wifi1
wifi2
(config)> network wifi radio
b. Determine the band for the appropriate radio:
(config)> network wifi radio wifi1 band
2400mhz
(config)>
c. Set the channel for the Wi-Fi radio:
(config)> network wifi radio wifi1 2400mhz channel value
(config)>
TX40 User Guide
Configure the Wi-Fi radio's channel
Wi-Fi1 radio
Wi-Fi2 radio
301