Digi TX40 User Manual page 137

Interfaces
5. The current carrier is highlighted in green. To switch to a different carrier:
a. Highlight the appropriate carrier and click SELECT.
The Carrier selection dialog opens.
b. For Carrier selection mode, select one of the following:
n
n

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type:
> modem scan
Issuing network scan, this may take some time...
Status
---------
Available
Available
Available
Available
Available
Available
Available
>
Show cellular status and statistics
You can view a summary status for all cellular modems, or view detailed status and statistics for a
specific modem.
TX40 User Guide
Manual/Automatic: The device will use automatic carrier selection if this carrier is
not available.
Manual: Does not allow the device to use automatic carrier selection if this carrier
is not available.
Note If Manual is selected, your modem must support the Network technology or
the modem will lose cellular connectivity. If you are using a cellular connection to
perform this procedure, you may lose your connection and the device will no longer
be accessible.
Carrier PLMN ID
-------- -------
T-Mobile 310260
T-Mobile 310260
T-Mobile 310260
AT&T 310410
Verizon 311480
311 490 311490
313 100 313100
Technology
----------
5G
4G
3G
4G
4G
4G
4G
Wide Area Networks (WANs)
137