Table of Contents
Advertisement
User authentication
n
Serial access
6. (Optional) Configure the serial ports to which users of this group have access:
a. Click Serial ports to expand the Serial ports node.
b. For Add Port, click .
c. In the Port dropdown, select a port.
d. Click again to add additional serial ports.
7. (Optional) Configure OpenVPN access. See for further information.
8. (Optional) Configure captive portal access:
a. Enable captive portal access rights for users of this group by checking the box next to
Captive portal access.
b. Click Captive portals to expand the Captive portal node.
c. For Add Captive portal, click .
d. In the Captive portal dropdown, select a captive portal to which users of this group will
have access.
e. Click again to add additional captive portals.
9. Interactive shell access
Shell access is not available if the Allow shell parameter has been disabled. See
access
for more information about the Allow shell parameter.
10. (Optional) Enable users that belong to this group to query the device for Nagios monitoring by
checking the box next to Nagios access.
11. (Optional) Enable users that belong to this group to access the Wi-Fi scanning service by
checking the box next to Wi-Fi scanner access.
12. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the add auth group command to add a new authentication. For example, to add a group
named test:
(config)> add auth group test
(config auth group test)>
TX40 User Guide
Authentication groups
Disable shell
847
Advertisement
Table of Contents
