Change The Default Hotspot Bandwidth Limits - Digi TX40 User Manual

Hotspot
(config)> network hotspot hotspot ipv4 address dhcp_server lease_start
value
(config)>
where value is any integer between 1 and 254. The default is 100.
c. Set the highest IP address in the range to assign to hotspot clients. This value represents
the low order byte of the IP address, and is combined with the subnet of the hotspot's
static IP address.
(config)> network hotspot hotspot ipv4 address dhcp_server lease_end
value
(config)>
where value is any integer between 1 and 254. The default is 250.
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Change the default hotspot bandwidth limits

Required configuration items
n Enable default hotspot configuration. See
instructions.
n Maximum download speed, in Kbps.
n Maximum upload speed, in Kbps.
To change the default hotspot IP address and subnet:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
TX40 User Guide
Enable hotspot using the default configuration
Use Digi Remote Manager to view and manage your
Hotspot configuration
for
363