Digi TX40 User Manual page 417

Routing
4. Click the  to add a new route policy.
5. For Label, type Route through cellular.
6. For Interface, select .
7. Configure the source address:
a. Click to expand Source address.
b. For Type, select Zone.
c. For Zone, select Internal.
8. Configure the destination address:
a. Click to expand Destination address.
b. For Type, select IPv4 address.
c. For IPv4 address, type the IP address that will be the destination for outgoing traffic
routed through the WWAN interface. In the above example, this is 241.236.162.59.
9. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
TX40 User Guide
IP routing
417